Aftermarket Carbon Fiber Hoods Installations


by Matt Brooks - Date: 2007-04-29 - Word Count: 385 Share This!

Once you have purchased the carbon fiber hood you want, it's time to get it installed. You may need a hand removing the factory hood due to its weight, but once it is removed, you should be able to handle the much lighter carbon fiber hood. The installation is fairly easy, so here is a quick guide to help you get it installed.

Start your installation by removing the windshield washer jets for the factory hood. Disconnect the tubing that runs to them by unclipping or unscrewing them. If there is a light attached to the hood, go ahead and remove it, as you may want to reuse it on the new hood.

With these removed, and with some help on the other side, prop the hood up with the hood prop if applicable. Remove the 4 bolts holding the hood to the hinges. If your hood has gas shocks, remove them before removing the hinge bolts. Be careful to support the weight of the hood when removing the hinge bolts to reduce the risk of damaging the fenders or the windshield. With the hinges and gas shocks unbolted, this will free up the heavy factory hood. Carefully remove it from the hinges by pulling it away from the windshield and set it aside.

Set the new carbon fiber hood in place. It will be significantly lighter than the factory steel hood. Line up the bolts on the hinges and tighten them down. Reattach the gas shocks if applicable, or set the hood prop in place. Reattach your windshield washer jets if your hood permits, and run the lines on the underside. If you saved your light and want to reattach it, you can do so at this point. it can be attached using some 3M adhesive double sided tape, or you can carefully screw it in place, making sure to use screws small enough to not penetrate the top of the hood.

Close the hood and check for alignment. If you need to adjust the alignment, lift the hood and loosen the hinge bolts slightly, just to where you can make small adjustments. Lower the hood and make any adjustments and re-tighten the bolts. This should complete your carbon fiber hood installation. Now you can enjoy the sleek new design and take it out for a test drive!


Related Tags: automotive, racing, aftermarket, auto accessories, lightweight, carbon fiber hood

Majestic Modifications is the complete car customization concept, specializing in aftermarket auto parts and car accessories, cold air intakes and performance upgrades, carbon fiber hoods and exterior accessories, glow gauges and interior accessories, wheels and tires, mobile video, car audio and electronics. For more information, visit the carbon fiber hoods blog.

Your Article Search Directory : Find in Articles

© The article above is copyrighted by it's author. You're allowed to distribute this work according to the Creative Commons Attribution-NoDerivs license.
 

Recent articles in this category:



Most viewed articles in this category: